How To Change Light Fixture High Ceiling

How to Change a Light Fixture on a High Ceiling

Changing a light fixture on a high ceiling can be a daunting task, but with the right tools and a little bit of know-how, it can be done safely and easily. Here are the steps on how to do it:

Safety First

Before you begin, be sure to turn off the power to the light fixture at the circuit breaker. This will prevent you from getting shocked while working on the fixture.

Gather Your Tools

You will need the following tools to change a light fixture on a high ceiling:
- A ladder
- A screwdriver
- Wire cutters
- Electrical tape
- New light fixture

Remove the Old Light Fixture

Once you have gathered your tools, you can begin to remove the old light fixture. First, use the screwdriver to remove the screws that are holding the fixture in place. Then, carefully pull the fixture down from the ceiling.

Disconnect the Wires

Once the fixture is down, you will need to disconnect the wires. Use the wire cutters to cut the wires about 6 inches from the fixture. Then, use the electrical tape to wrap the ends of the wires.

Connect the New Light Fixture

Now you can connect the new light fixture. First, strip about 1 inch of insulation from the ends of the wires. Then, twist the ends of the wires together and secure them with electrical tape.

Mount the New Light Fixture

Once the wires are connected, you can mount the new light fixture to the ceiling. First, hold the fixture in place and mark the location of the screw holes. Then, drill pilot holes for the screws. Finally, insert the screws and tighten them until the fixture is secure.

Turn on the Power

Once the light fixture is mounted, you can turn on the power at the circuit breaker. Then, test the fixture to make sure it is working properly.

Tips

Here are a few tips for changing a light fixture on a high ceiling:
- If you are not comfortable working on a ladder, you can hire an electrician to do the job for you.
- Be sure to wear safety glasses when working on a light fixture.
- If you are not sure how to wire the light fixture, consult an electrician for help.
- Once the light fixture is installed, be sure to clean up any debris.