Reprogram Hunter Ceiling Fan Remote Control

Reprogramming Your Hunter Ceiling Fan Remote Control

Reprogramming your Hunter ceiling fan remote control is a simple task that can be completed in a few minutes. By following these steps, you can ensure that your remote control is working properly and that you have full control over your ceiling fan.

1. Locate the reset button The reset button is typically located on the back of the remote control. It is usually a small, recessed button that is labeled "Reset." 2. Press and hold the reset button Use a paper clip or other pointed object to press and hold the reset button for about 10 seconds. The remote control will beep and the LED light will flash to indicate that it has been reset. 3. Release the reset button Once the remote control has been reset, release the reset button. The remote control is now ready to be reprogrammed. 4. Press the desired fan speed button Press the button on the remote control that corresponds to the desired fan speed. The fan will start spinning at the selected speed. 5. Press the light button Press the light button on the remote control to turn on the light. The light will turn on at the lowest brightness setting. 6. Press the light up or down button Press the light up or down button on the remote control to adjust the brightness of the light. The light will get brighter or dimmer depending on which button you press. 7. Press the fan off button Press the fan off button on the remote control to turn off the fan. The fan will stop spinning and the light will turn off.