How To Fix Pull Chain On Hunter Ceiling Fan Light

If you're having trouble with the pull chain on your Hunter ceiling fan light, don't worry - you're not alone. This is a common problem that can be easily fixed with a few simple steps. In this article, we'll walk you through the process of how to fix a pull chain on a Hunter ceiling fan light.

Tools you'll need

Before you begin, you'll need to gather a few tools to help you: A pair of needle-nose pliers A small screwdriver A wire cutter Electrical tape

Safety first

Before you start working on your ceiling fan, be sure to turn off the power at the circuit breaker. This will help to prevent any electrical shocks.

Step 1: Remove the light fixture cover

The first step is to remove the light fixture cover. To do this, simply unscrew the screws that are holding it in place. Once the screws are removed, you should be able to pull the light fixture cover off of the ceiling fan.

Step 2: Locate the pull chain switch

Once the light fixture cover is removed, you should be able to see the pull chain switch. The pull chain switch is usually located near the center of the fan. It is a small, plastic switch that has two wires coming out of it.

Step 3: Disconnect the wires

The next step is to disconnect the wires from the pull chain switch. To do this, simply use the needle-nose pliers to gently pull the wires out of the switch. Be careful not to pull too hard, or you could damage the wires.

Step 4: Cut the wires

Once the wires are disconnected, you can use the wire cutter to cut them. Cut the wires about 1 inch from the switch.

Step 5: Strip the wires

Once the wires are cut, you need to strip the insulation off of the ends of the wires. To do this, simply use the small screwdriver to scrape off about 1/2 inch of the insulation from each wire.

Step 6: Connect the wires to the new pull chain switch

Now it's time to connect the wires to the new pull chain switch. To do this, simply insert the stripped ends of the wires into the terminals on the new switch. Make sure that the wires are inserted all the way into the terminals, and then tighten the screws to secure them.

Step 7: Install the new pull chain switch

The next step is to install the new pull chain switch. To do this, simply insert the switch into the hole in the light fixture cover. Once the switch is in place, tighten the screw to secure it.

Step 8: Reinstall the light fixture cover

Now it's time to reinstall the light fixture cover. To do this, simply line up the light fixture cover with the ceiling fan and then screw it into place. Be sure to tighten the screws securely.

Step 9: Turn on the power

Once the light fixture cover is reinstalled, you can turn on the power at the circuit breaker. Once the power is turned on, test the new pull chain switch to make sure that it is working properly.

Conclusion

If you have followed all of the steps in this article, you should now be able to fix the pull chain on your Hunter ceiling fan light. If you are still having problems, you may need to call a qualified electrician for help.