How To Put Pot Lights In A Finished Ceiling

Installing recessed lighting in a finished ceiling is a relatively straightforward process, but it does require some planning and preparation. By following these step-by-step instructions, you can easily add recessed lighting to your home in a few hours.

### Materials You'll Need

Recessed lighting fixtures
Electrical wire
Wire nuts
Drill
Hole saw
Screwdriver
Electrical tape
Insulation

### Step-by-Step Instructions

1. Choose the Location of Your Lights

Before you start drilling any holes, it's important to determine where you want your recessed lights to be placed. Consider the size of the room, the furniture layout, and the amount of natural light that is available.

2. Drill the Holes

Once you have chosen the location of your lights, it's time to drill the holes. Use a hole saw that is slightly larger than the diameter of the recessed lighting fixtures. Drill the holes so that the edge of the hole is flush with the ceiling.

3. Run the Electrical Wire

Next, you need to run the electrical wire from the junction box to the recessed lighting fixtures. Use electrical wire that is rated for the amperage of the lights you are using. Connect the wires to the recessed lighting fixtures using wire nuts, and then secure the wires to the ceiling with electrical tape.

4. Install the Insulation

Before you install the recessed lighting fixtures, you need to install insulation around the holes. This will help to prevent heat from escaping from the room.

5. Install the Recessed Lighting Fixtures

Now you're ready to install the recessed lighting fixtures. Insert the fixtures into the holes and secure them with screws. Make sure that the fixtures are level and that the trim is flush with the ceiling.

6. Turn on the Lights

Once the recessed lighting fixtures are installed, turn on the lights and enjoy the new ambiance in your home.

### Tips

If you are not comfortable working with electricity, it's best to hire an electrician to install your recessed lighting.
Be sure to turn off the power at the breaker box before you begin working.
Use a level to make sure that the recessed lighting fixtures are level.
Insulate around the holes to prevent heat from escaping from the room.
Enjoy the new ambiance in your home!