How To Reset My Hunter Ceiling Fan Remote

How to Reset Your Hunter Ceiling Fan Remote

If you're having trouble with your Hunter ceiling fan remote, resetting it may be the solution. Here's a step-by-step guide on how to reset your Hunter ceiling fan remote:

Step 1: Turn off the Power

Before you start, turn off the power to your ceiling fan at the circuit breaker or fuse box. This will prevent any electrical shock.

Step 2: Remove the Remote Battery

Open the battery compartment on the back of the remote and remove the battery. Wait for a few minutes before reinserting the battery.

Step 3: Reset the Receiver

Locate the receiver box on the ceiling fan. It's usually a small white or gray box attached to the fan's motor housing. Press and hold the reset button on the receiver for about 10 seconds. The LED light on the receiver will flash to indicate that it has been reset.

Step 4: Reinstall the Battery

Reinsert the battery into the remote and close the battery compartment.

Step 5: Turn on the Power

Turn on the power to your ceiling fan at the circuit breaker or fuse box.

Step 6: Test the Remote

Press the buttons on the remote to test if it's working properly. If the fan responds to the remote commands, then the reset was successful.

Step 7: Troubleshooting

If the remote is still not working after following these steps, there may be another issue. Check the following:

Make sure the remote is pointed at the receiver.
Replace the battery in the remote.
Check the wiring connections between the receiver and the fan.
Contact Hunter Customer Support for further assistance.

Additional Tips

Here are a few additional tips for resetting your Hunter ceiling fan remote:

If you have multiple remotes for the same fan, you may need to reset all of them.
If you're still having trouble after following these steps, try contacting Hunter Customer Support.